AVer VC520 Pro - Install Aver Ptzapp



Install AVer PTZApp
In AVer PTZApp, user can configure the parameters of the camera.
Please go to http://www.aver.com/download-center to download the AVer PTZApp. After downloading,
double-click on the file and follow the on-screen instructions to complete the installation.
Use AVer PTZApp
1. After installing the AVer PTZApp, double-click on the
AVer PTZApp icon to run the application.
2. During your video call, you can use the AVer
PTZApp to pan, tilt and zoom the camera in/out and
enable/disable the backlight feature, set up camera
Home or Sleep mode preset points. For more
details, please refer to the user manual.
3. Tracking mode: It is a SmartFrame function which
can auto detect faces of people to find the best view
for all meeting participants. Users can change
SmartFrame function status in AVer PTZApp. In
AVer PTZApp, select “Settings” > “Tracking mode”
> “Auto frame/Manual frame/off”.
Also, pressing on the remote for 1 second
can switch the SmartFrame function between auto
and manual; a message (as figure shown) will
display on the screen to indicate in auto or manual
status.
[Note]
While in conferencing meeting, participants
must face the camera for face detection
(SmartFrame).
4. Flip: If the camera is installed in the upside down
position, please enable the "Flip" function in the
AVer PTZApp, and the screen will display normally.