Avery Dennison ADTP1 - Setting the Printhead Type; Procedure for Setting Printhead Type; Replacing the Printhead; Procedure for Replacing Printhead

2
Setting the Printhead Type
To set the Printhead Type:
1. From the Main Menu select TLABEL.
2. Press . You see Printhead Type.
3. Press SELECT.
4. Press  or  until you see the Printhead Type you
need (Type R or Type K), then press SET.
5. Press BACK until you see “Ready,” then press
SELECT.
Replacing the Printhead
To replace the printhead:
1. Turn off the printer.
2. Open the cover.
3. Unlock the printhead by turning the retaining latch.
4. Press forward and down on the two latches on top
of the printhead assembly as shown. The printhead
will drop out.
5. Lift the printhead assembly using the printhead tab
and push back until the printhead assembly clicks
into place.