To Next PageTo Next PageWhy is my Avery Dennison Pathfinder 6140 not connecting to my smart device?
If your Avery Dennison printer isn't connecting to your smart device, ensure you're using a fully charged battery. Verify that the printer and device aren't too far apart (ideally within 10 meters, line of sight). Also, confirm that no other smart device is already connected to the printer and that Bluetooth is enabled on your smart device.
How to fix Avery Dennison Printer that does not print correctly?
If your Avery Dennison printer is not printing, producing voids, or the print is too light, try these steps: Use a fully-charged battery. Ensure the supply is loaded correctly. Clean the printhead. Completely close the supply cover. Make sure your printer and smart device are connected.
What to do if my Avery Dennison Pathfinder 6140 Printer fails to respond?
If your Avery Dennison printer is failing to respond, try the following: Ensure you are using a fully charged battery. Make sure the supply is loaded correctly. Clear any jammed labels. Clean the printhead. Check that your printer and smart device are properly connected.
What to do if my Avery Dennison Printer does not feed?
If your Avery Dennison printer is not feeding, ensure you're using a fully-charged battery and that the supply is loaded correctly. Also, clear any jammed labels that may be causing the issue.
How to troubleshoot Avery Dennison Pathfinder 6140 Printer when the scanner does not scan a bar code?
If the scanner on your Avery Dennison printer isn't scanning barcodes, try altering the scan angle and distance. Clean the scanner window and check the barcode for voids.
General| Brand | Avery Dennison |
|---|---|
| Model | Pathfinder 6140 |
| Category | Printer |
| Language | English |
Introduces the 6054 Network Control Module and 6055 Docking Module, detailing their functions and printer compatibility.
Advises charging the printer before use to prevent permanent loss of battery charge capacity.
Instructions on turning over modules and removing the end cap from the Network Control Module.
Details attaching the connector plate to the 6055 Docking Module using a Philips screwdriver.
Steps for attaching the 6054 Network Control Module to the Docking Module and re-attaching the end cap.
Guide on connecting up to four Docking Modules sequentially to the Network Control Module.
Instructions for plugging in the power cable and connecting the communication cable from the host.
Specifies required power supply models and surge protector for compliance in Brazil.
Details inserting the printer into the Docking Module and estimated charging times to 80% and 100%.
Explains the function and behavior of the Charging LED and Complete LED during battery charging.
Lists the default LED color indicators for printer status like error, out of supply, and low battery.
Provides steps to resolve charging errors indicated by blinking LEDs on the Docking Module.
Details temperature and humidity ranges for operating and storing the equipment.
Provides dimensions, weight, and power specifications for the modules and power supply.
