To Next PageTo Next PageWhat to do if my Avery Dennison Pathfinder 6059 does not print?
If your Avery Dennison printer isn't printing, try the following: ensure you're using a fully charged battery, load the supply correctly, or clean the printhead.
What to do if my Avery Dennison Pathfinder 6059 Printer does not feed?
If your Avery Dennison printer isn't feeding, try these steps: switch to a fully charged battery, ensure the supply cover is completely closed, load the supply correctly, check the platen roller for jammed labels, and make sure the pinch roller is in place.
What to do if my Avery Dennison Pathfinder 6059 partially prints?
If your Avery Dennison Printer partially prints on the supply and fails to respond to the keypad or trigger, try loading the supply correctly, using new supplies if necessary, clearing any supply jams, cleaning the printhead, or switching to a fully charged battery.
What to do if my Avery Dennison Pathfinder 6059 print has voids or is too light?
If the print from your Avery Dennison printer has voids or is too light, try loading the supply correctly, ensuring the supply cover is completely closed, using a fully charged battery, cleaning the printhead, or checking the supply for damage or defects.
Why does the display not turn on and a label with an overstrike pattern prints on my Avery Dennison Printer?
If the display of your Avery Dennison printer doesn't turn on and a label with an overstrike pattern prints, it's because the RFID inlay failed to encode. Make sure the power is on and switch to a fully charged battery.
General| Print Technology | Thermal Transfer |
|---|---|
| Print Resolution | 203 dpi |
| Connectivity | USB, Bluetooth |
| Supported Media Types | Labels, Tags |
| Operating Temperature | 41°F to 104°F (5°C to 40°C) |
| Humidity | 10% to 90% non-condensing |
| Storage Temperature | -20°C to 60°C (-4°F to 140°F) |
Turn over modules, remove end cap from Network Control Module, and attach connector plate.
Attach end cap to Docking Module and connect multiple docking modules to the network control module.
Plug power cable into module and outlet, then connect the communication cable from the host.
Specific power source requirements for Brazil compliance, listing compatible models and specifications.
Slide printer into module until click; charging takes up to four hours for full capacity.
Understand LED behavior for 80% and 100% charge levels and blinking status.
Explains LED colors (Red, White, Blue) and their meanings for printer status.
Describes LED behavior when the printer is docked (green, magenta blinking).
Procedure to resolve errors indicated by blinking LEDs, including re-inserting printer or replacing battery.
Specifies temperature and humidity ranges for operation and storage.
Lists physical dimensions and weight for Docking Module and Network Control Module.
Details input and output specifications for the power supply unit.
