Avery Dennison Pathfinder 6140 - Setting up the Network Control Module; Connecting Power and Communication; Brazil Power Supply Compliance

4 Classification: Avery Dennison – Public
Setting u p the Network Control Module
1. Plug the supplied power cable into the Network
Control Module.
2. Plug the other end of the cable into a grounded
electrical outlet. The green power LED on the 6054
Network Control Module turns on.
3. Connect the communication cable from the host to
the Network Control Module.
For Use in Brazil
In order to meet the compliance requirements of Brazil,
Network Module, whose model is 6054, should be fed by
the source model:
FSP FSP084-DMAA1, Input: 100-240Vac, 50-60Hz, 1.3A,
Output: 12Vdc, 7.0A, LPS. Or Edac Power Electronics
Co.
And 10953A Input: 100-240Vac, 50-60Hz, 2.5A, Output:
+12 Vdc, 6.6a, 80W, LPS. along with the surge protector
model Clone F1W.
A fim de atender aos requisitos de conformidade do
Brasil, o Network Module, cujo modelo é 6054, deve ser
alimentado pela fonte de modelo:
FSP FSP084-DMAA1, Input: 100-240Vac, 50-60Hz, 1.3A,
Output: 12Vdc, 7.0A, LPS. ou Edac Power Electronics
Co., E 10953A Input: 100-240Vac, 50-60Hz, 2.5A,
Output:+12Vdc, 6.6A, 80W, LPS
junto com o protetor de surto de modelo Clone F1W.
Communication Cable
goes here