Classification: Avery Dennison – Public 5
Charging the Battery
Charge the battery while it is inside the printer. Slide the
printer into the Docking Module until you hear a click.
The green power LED on the 6054 Network Control
Module turns on when there is power to it.
Charging time can take up to four hours. It takes
approximately 2 hours to reach the 80% level (where it is
now usable). To reach 100%, it takes approximately 2
hours more.
Reading the Display
♦ Charging LED – flashes
when you insert the
printer; on (solid) during
charging; off when charging is complete.
♦ Complete LED – flashes when the printer’s battery is
80% charged; on (solid) when the battery is 100%
charged.
Why is the charging status LED blinking again?
Once the battery reaches 100% charged, it remains at
100% for a period of time before continuously cycling
between 80% - 100% charged.
To Next Page
Loading...
