Why does Avery Dennison ADTP1 MonarchNet2 All in One Printer show 'Error sending the discovery request'?
If you see an “Error sending the discovery request” message on your computer or Web browser, it means the printer is not communicating on the network. You should verify network and wireless settings, including the IP address.
What to do if MonarchNet2 does not appear to be working on Avery Dennison ADTP1 MonarchNet2?
If MonarchNet2 does not appear to be working, try turning off the printer and then turning it back on. Print a MN2 test label to confirm the IP address. Then, enter the correct IP address in your Web browser.
What to do if Avery Dennison All in One Printer does not communicate with your network?
If the printer does not communicate with your network, ensure the network settings match the printer’s settings for the following: IP address, gateway, and subnet mask; SSID; Ad-Hoc or infrastructure mode; and Security.
What to do if Avery Dennison ADTP1 MonarchNet2 All in One Printer cannot be seen on the network?
If you cannot see the printer on the network, make sure the devices are on the same logical network and that the subnet masks are the same.
What to do if Avery Dennison ADTP1 MonarchNet2 All in One Printer does not communicate with access point?
If you have reset network or wireless settings, allow time for the printer to reset and connect to an access point. This may take a minute or more, depending on network traffic.
What does 'Authorization Failure' mean from MonarchNet2 on Avery Dennison ADTP1 MonarchNet2?
If you receive an “Authorization Failure” message from MonarchNet2, it indicates that you need to enter the correct password when logging in. The default password is 'access'.
Why Avery Dennison All in One Printer configuration label shows “searching” or “set manually” for boot method/DHCP?
The message “searching” indicates the printer has not yet connected to the network. The message “set manually” indicates the boot method is Static. If the boot method is not Static, the printer was not able to connect to the network.
Why Avery Dennison All in One Printer does not appear to save IP, subnet, or gateway address?
The value for each segment must be less than 255 in these addresses.
Manual's intended audience and prerequisites for using the wireless module.
Steps to verify the printer's wireless connection status and signal strength.
Instructions for printing a test label to check printer and network configuration.
Procedure for accessing the printer's web interface using its IP address.
Configuring printer options like ribbon, supply type, feed mode, and system settings.
Setting up TCP/IP, SNMP, and wireless network parameters for connectivity.
Configuring encryption, authentication, WEP keys, and certificates for wireless networks.
Network reset, virtual panel access, custom commands, and password management.
Steps to establish a Telnet session for direct console command access.
Guide to console commands for printer management, network setup, and troubleshooting.
Using test labels to diagnose printer and network communication issues.
Resolving connectivity, network, and web browser access issues.
Definitions of key terms and acronyms used throughout the manual.
General| Brand | Avery Dennison |
|---|---|
| Model | ADTP1 MonarchNet2 |
| Category | All in One Printer |
| Language | English |
To Next Page