Avery Dennison ADTP1 MonarchNet2 - Printer Specifications and Verification; Verifying Wireless Connection; Printing a MonarchNet2 Test Label

1-2 MonarchNet2 Operating Instructions
Specifications
Link Layer:
802.3 or optional 802.11a/b/g/n
Protocols:
TCP/IP
Passthru
DHCP
LPD/LPR
Telnet
RSH (remote shell)
FTP
SNMP
HP JetAdmin™
802.3 Communication Rate:
10 Mbps or 100 Mbps
Frequency:
2.4 GHz range, direct sequence
Communication
Rate:
1, 2, 5.5, 11, 12, 18, 24, 36, 48, or 54 megabits per second
Channels
1 to 11
Mode:
Ad-Hoc or infrastructure
Encryption:
WEP 64 or WEP 128
WPA or WPA2
Authentication:
EAP-FAST
LEAP
PEAP
TLS
TTLS
PSK
Verifying a Wireless Connection
When the printer is turned on, the wireless module runs through a set of power-up diagnostics for a
few seconds. Then the display shows the wireless connection icon, wireless connection signal
strength, and your printer’s IP (Internet Protocol) address.
Printing a MonarchNet2 Test Label
Press TLABEL and select Mnet2 Label
Wireless icon and signal strength
IP Address