Using a Web Browser2-5
Configuring the Network Settings
You can configure the printer to operate on your network.
1. From the side Menu Bar, click Network Configuration.
2. Select one of the following tabs: Protocols, SNMP, Wireless, or Alerts.
Changing TCP/IP Settings
Only configure the settings required for your network/printer.
1. On the Protocols tab, set the Boot Method: Auto, DHCP, or Static.
2. Set the number of Boot Tries: 1-10. The default is 3. If you are having a problem receiving an
IP address with BOOTP, set this number to 10.
3. Change the IP Address if necessary.
4. Set or change the Subnet Mask.
5. Set or change the Gateway.
6. Select either No Subnet or No Gateway for RARP.
7. Select Automatic DNS Settings to automatically configure the domain name settings.
8. Enter the Domain Name.
9. Enter the Primary DNS Server’s IP address.
10. Enter the Secondary DNS Server’s IP address.
11. Select Enable Network Time to enable the network time protocol, which allows the printer to
query a time server on the network and synchronize the clock in the printer.
To Next Page
Loading...