Using a Web Browser2-3
Configuring the Printer
You can configure the printer using your Web browser.
1. From the side Menu Bar, click Printer Configuration.
2. Select one of the following tabs: Printer Setup or Supply Setup.
Changing the Printer Setup
Only configure the settings required for your network/printer.
Note: Only the available options for your printer are displayed.
1. On the Printer Setup tab, set the Ribbon: None, Ribbon, or High Energy.
2. Set the Supply Type: Edge Aperture, Edge Die Cut, Edge Black Mark, Continuous, Center
Aperture, Center Die Cut, or Center Black Mark.
3. Set the Feed Mode: Continuous, On Demand, or Liner take-up (optional).
4. Enter a value for the Cut Adjust (Position). The range is –300 to 300. This adjusts where the
tag is cut.
5. Enter a value for the Supply Position. The range is –300 to 300. This adjusts the printer to
print at the vertical 0,0 point. Only adjust on initial printer setup.
6. Set the Batch Separators: No, Yes, or Long.
7. Set the Skip Index mode: No or Yes. Skip index allows you to print an image over multiple
labels.
8. Set the Backfeed: Off, On, or Extended. Backfeed advances each printed label to the specified
dispense position and then backs up the next label to be printed underneath the printhead. Do
not use extended backfeed on printers without a cutter.
9. Enter a value for the Dispense Position (range is 50 to 200). This adjusts the stopping point of
the label after it is printed.
10. Enter a value for the Backfeed Distance (range is 20 to 200). This is the amount to move the
label backwards before printing.
To Next Page
Loading...