2-4 MonarchNet2 Operating Instructions
11. Enter a value for the Contrast (range is –699 to 699). This adjusts the darkness of printing on
the supply.
12. Enter a value for the Print Position (range is –450 to 450). This adjusts where data prints
vertically on the supply.
13. Enter a value for the Margin Position (range is –99 to 99). This adjusts where data prints
horizontally on the supply.
14. Click Submit when finished.
Changing the System Setup
Only configure the settings required for your printer.
1. On the System Setup tab, set the Flash Storage: Enabled or Disabled. Flash storage allows
packets with “R” or “N” selectors to be stored in Flash Memory, instead of volatile RAM. Packets
stored in flash memory are saved when the printer is turned off.
2. Set the Speed Adjustment: Default, 2.5, 4.0, 6.0, 8.0 10.0, or 12.0 ips. If you select “Default,”
serial bar codes print at 2.5 ips; parallel bar codes print at 6.0 ips.
3. Set the Power Up Mode: Online or Offline.
4. Select the Language.
5. Set the Monetary Sign: None, USA, UK, Japan, Germany, France, Spain, Italy, Sweden,
Finland, Austria, India, Russia, Korea, Thailand, China, Euro-Dollar.
6. Set the Secondary Sign: No or Yes.
7. Set the number of Decimal Places: 0, 1, 2, or 3.
8. Select Slashed Zero to print zeros with a slash (Ø): No or Yes.
9. Click Submit when finished.
To Next Page
Loading...