3-2 MonarchNet2 Operating Instructions
4. To view the current wireless (or network) settings, type sh en (show wireless settings) then
press Enter:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: ABC123
Speed = 54
International Roaming: Flexible
Dynamic Frequency Selection: Unsupported
Regulatory Domain = USI
WiFi FW Ver = 2.13.10.0 LMAC, 2.12.18.0 UMAC
AP density = LOW
Authentication type= OPEN SYSTEM
Encryption is Disabled
Local certificate loaded
AP MAC Address = 00 A0 F8 51 B4 FC
Signal Quality = Excellent (100%)
Connected to SSID ENG4121 on channel 11
5. To show the current IP settings, type ship (show TCP/IP settings) then press Enter.
IP is enabled
IP address 192.0.0.192 Boot tries 3
Subnet mask 255.255.0.0 Boot method AUTO
IP Gateway 192.1.1.192 Max window 10240
(via DHCP 192.2.2.192)
LPD banner disabled Timeout 0 min
LPD retries are disabled Keepalive 1 min
Service Port TCP port
PXR1E8580_X1 X1 9100
6. To change the SSID, type set en ssidtestsystemthenpress Enter.
7. To set the IP address, type set ipad 192.0.0.192then pressEnter.
8. To set the subnet mask, type set ipsub 255.255.0.0then pressEnter.
9. Type INIT and press Enter to save the settings and initialize the unit.
10. Type EXIT to exit Telnet.
See the following sections for a list of the most frequently used commands.
Help Commands
For help at any time, type “Help” and a list of available commands appears. The Help command
builds on itself, because for each command you type, more details appear for each option.
Note: There are help menus for all supported commands. To access a help menu for a specific
command, type Help<command>.
Syntax: Help set
DEFAULT Set parameters to factory defaults
EN Network Parameters
LOAd Firmware update parameters
PAssword<password> Set console password
PORt<name> . Parameter for port <name>
SERVEr Server and LAT parameters
SERVIce<name> Service Parameters
SNMP SNMP Variables
Syslog Syslog Parameters
DNS DNS Parameters
STRing n "..." BOT/EOT string
IP LPD/TCP Parameters
POWERON <delay-sec> Power on delay
To Next Page
Loading...