Avery Dennison ADTP1 MonarchNet2 - General Commands

Console Commands3-3
Displays a list of the available help commands for “Set.”
Syntax: Help set ip
IP LPD/TCP Parameters
ADdress aa.bb.cc.dd IP node address
ARP [EN/DIS] IP set via ARP
BAnner [EN/DIS] LPD banner printing
CHKSUM [EN/DIS] IP receive checksum
BOot n Number of DHCP/BOOTP tries
ENable/DISable Enable or Disable IP Processing
FTIme [EN/DIS] Fast timeout
FTP [EN/DIS] FTP protocol
HTTP [EN/DIS] HTTP protocol
KEepalive n Keepalive interval (min)
LPD [EN/DIS] LPD protocol
MEthod<type> Set method of getting IP address
PIng aa.bb.cc.dd Test connection to IP host
PRObe [EN/DIS] TCP connection probes
RANge [EN/DIS/ALL] aa.bb.cc.dd {MAxee.ff.gg.hh}
RARp flags nn 1=no subnet, 2=no router, 3=neither
REtry [EN/DIS] LPD retry continuation
ROuter aa.bb.cc.dd Default router address
SUbnet aa.bb.cc.dd Subnet mask
TCP [EN/DIS] Raw TCP (9100) protocol
TELnet [EN/DIS] TELNET protocol
TFTP [EN/DIS] TFTP protocol
TImeout n Inactivity timeout (minutes)
TRAP n [ADDR/PORT/TRIG] TRAP configuration
WIndownn LPD/TCP maximum window size
Displays a list of the available help commands for “Set IP.”
General Commands
From the list of commands, the brackets - [] indicate to pick one of the options listed, the items
inside curly braces - {} are optional and do not need to be specified.
Set/CLear/DElete/PUrge
Used in conjunction with additional parameters.
EXIT
Exits console mode.
HElp
Displays the list of available commands.
SET
Sets a specified parameter.
SHow
Displays current settings.
INIT
Saves settings and initializes unit.
SET DEFAULT
Sets wireless module to factory defaults.
SET PAssword
Sets console password. The user is prompted for old password, new password, and to verify new password.
The default password is access.
Note: The password is case-sensitive.
SET SERVErNAme<name>