Avery Dennison ADTP1 MonarchNet2 - RFID Commands; 802.11 B;G Wireless Commands; TCP;IP Commands

Console Commands3-7
RFID Commands
SHow PRN RFId {MOduletype/ VErsion/ WRiteattempts/ PRotocol/ RPower/ WPower/
REgion/ FRequency/ SUmmary}
Shows the specified RFID parameter’s current setting. If no parameter is specified, it shows the current
settings of all parameters in the RFID category.
CLear PRN RFIdSUmmary
Clears RFID summary data (number of good and bad RFID tags).
802.11b/g Wireless Commands
In the following commands, EN and NW (network settings) are interchangeable.
CLear EN SSid
Clears the SSID, so the server connects to any access point.
SET EN AUTHtype [OPEN/SHARED/TTLS/LEAP/PEAP/WPA-PSK]
Sets the authentication type. See Chapter 3, “Using the Web Browser” for more information.
SET EN ENC [DISable/64/128/WPA/WPA2/WPA2-WPA/
Dynamic WEP]
Sets the encryption mode. See Chapter 3, “Using the Web Browser” for more information.
SET EN INAP [PAP/MSCHAP_V2]
Sets the EAP inner authentication protocol.
SET EN KEY# <1/2/3/4>
Sets which WEP key number to use (default is 1).
SET EN KEYVAL <WEPkey>
Sets WEP key value.Must be hexadecimal.
SET EN MODE [IN/AD]
Sets 802.11b/g/n wireless mode to infrastructure or Ad-Hoc mode.
SET EN ROAm
Sets the Roam Threshold.
SET EN SSID “<ssid>”
Sets 802.11b/g/n wireless SSID. Use quotes if there is a space in SSID. This is case sensitive.
SET EN WPAPSK <WPAkey>
Sets the WPA pre-shared key or pass-phrase. Use 64 hex characters for the PSK or 8-63 characters for the
pass-phrase. This is only valid when authentication mode is WPA-PSK.
TCP/IP Commands
SET IP ADdress
Sets IP address of wireless module.
SET IP BOot n
Sets number of retries (n) for DHCP, BOOTP, RARP
SET IP KEepalive n
Sets keep alive interval (n) in minutes.
SET IP MEthod [DHCP/STATIC]
Sets method of getting IP address.
SET IP SUBnet aa.bb.cc.dd
Sets default subnet mask.
SET IP TImeout n
Sets timeout (n) in minutes.