3-6 MonarchNet2 Operating Instructions
SHow PRN STOrageFORmats {format # or ALl}
Shows headers for individual or all formats. Note that ‘0’ is shorthand for ‘ALl’.
SHow PRN STOrageFONts
Shows headers for all fonts.
CLear PRN STOrage [RAm/ FLash] FORmats [format # or ALl]
Clears the specified format or all formats from volatile RAM or flash memory. Note that ‘0’ is shorthand for
‘ALl’.
CLear PRN STOrage [RAm/ FLash] FONts [font # or ALl]
Clears the specified font or all fonts from volatile RAM or flash memory.
Note that ‘0’ is shorthand for ‘ALl’.
CLear PRN STOrage [RAm/ FLash] GRaphics [graphic # or ALl]
Clears the specified graphic or all graphics from volatile RAM or flash memory. Note that ‘0’ is shorthand for
‘ALl’.
CLear PRN STOrage [RAm/ FLash] CDigits [CD scheme #]
Clears the specified check digit scheme from volatile RAM or flash memory.
SET PRN SUPply [TYpe/ RIbbon/ FEedmode/ SUpplyposition/ CUtposition/
SKipindex/ KNifecontrol/ ERroraction] value
Sets the specified supply parameter to the specified value.
SHow PRN SUPply [TYpe/ RIbbon/ FEedmode/ SUpplyposition/ CUtposition/
SKipindex/ KNifecontrol/ ERroraction]
Shows the specified supply parameter’s current setting. If no parameter is specified, it shows the current
settings of all parameter’s in the supply category.
SHow PRN SUPplySYncsupply
Resynchronizes the supply.
SET PRN SYStem [POwerupmode/ LAnguage/
BAtchseparators/SLashedzero/SYmbolset] value
Sets the specified system parameter to the specified value.
SHow PRN SYStem {POwerupmode/ LAnguage/
BAtchseparators/SLashedzero/SYmbolset}
Shows the specified system parameter’s current setting. If no parameter is specified, it shows the current
settings of all parameters in the system category.
SET PRN SCRipts [LOad/ ENable/ DISable/ DELETE]
Loads, enables, disables, or deletes a script. Note that LOad, ENAble, DISable, and DELETE take no
arguments.
SET PRN SCRipts [ENQpollbeforescript/ IMmcmdbeforscript] value
Sets the specified scripts parameter to the specified value.
SHow PRN SCRipts {STatus/ INfo/ ENQpollbeforescript/ IMmcmdbeforescript}
Shows the specified scripts parameter’s current setting. If no parameter is specified, it shows the currents
settings of all parameters in the scripts category.
SET PRN VERifier [STate/ SCanbeam/ CAbledetect] value
Sets the specified verifier parameter to the specified value.
SHow PRN VERifier {STate/ SCanbeam/ CAbledetect/ SUmmary}
Shows the specified verifier parameter’s current setting. If no parameter is specified, it shows the current
settings of all parameters in the verifier category.
CLear PRN VERifierSUmmary
Clears the verifier summary data (number of good and bad verifier labels).
To Next Page
Loading...