2-6 MonarchNet2 Operating Instructions
12. Enter the Time Server’s IP address. The printer waits 20 seconds for the server to respond.
The status is displayed within parentheses: “Waiting for Server,” “Time Server Error,” or the
current date and time.
13. Enter the Time Zone Adjustment in hours and minutes, from Greenwich Mean Time (GMT).
This offset varies by location and time zone. For example, Eastern/Standard time is five hours
behind GMT. Use –5:00 for the offset. For an offset of 3.5 hours, use 3:30.
Note: Changes for Daylight Savings Time are not made automatically. If your time zone
participates in Daylight Savings Time, change the time zone offset accordingly.
14. Set the TCP Window. 10240 is the default.
15. Set the TCP Port. Port 9100 is the default.
16. Set the TCP Timeout (in minutes). The default is 0, which is no timeout.
17. Set the Keepalive Timer (in minutes). The default is 1 minute.
18. Enable or Disable IP Receive CheckSum and Probe Idle Connections.
19. Select Retry Enable for LPD/LPR.
20. Select Enable Web Authorization Timeout to make the Web pages time out after five (5)
minutes of inactivity.
Note: The time out period is set for five minutes and cannot be changed.
21. Select Enable HP Jet Admin if using HP Jet Admin. No other settings are required for HP
JetAdmin.
22. Click Save Changes to save changes or click Save/Re-init Network to save the changes and re-
initialize the network with the new settings. Any changes made on this screen or other screens
do not take effect until you click Save/Re-init Network.
This process takes a few minutes.
To Next Page
Loading...