11/07 Rev. 4.03-01 USER-/SERVICE MANUAL Technical Data
AP7.t
4
Punch sensor Transmission sensor, detects punches or gaps in the label material; adjusta-
ble from the left side about half of the material width (Tab. 2).
Reflex sensor
• Optional available
• Detects reflex marks on the label material (normally dark marks on light
background)
• Adjustable from the left side about half of the material width.
[2] Measures and setting range of the punch / reflex mark (c = setting range, b = punch
length, a = punch width).
Fonts • 19 Fixsize fonts , including OCR-A and OCR-B, including 2 fonts with textile
symbols
• 3 scalable fonts (Speedo fonts)
• Truetype fonts are supported
• Optionally can Truetype, Speedo and Fixsize fonts be stored on a CF-card
Modifying Fonts • Up to factor 8 scaling in x/y direction
• Rotation by 0, 90, 180 and 270 degrees
Measure Transmission Reflex
Setting range c Material zero line up to
60 mm
(Material zero line +
6mm) up to 66mm
Punch length b 0.8–14mm 4mm (recommended)
Punch width a min. 4mm 12mm (recommended)
[Tab. 2] Recommended punch dimensions.
a
b
c
Z0211.cdr
Punch / Reflex markPunch sensor Label webMaterial zero line
To Next Page
Loading...
