Taiwan EMC Regulations
73
Operation manual should have following statement and statement should be shown on device, or
put on similar sentence:
3. Heat-related hazards
Injury may result from high temperatures under normal operating conditions, causing:
- Burns due to contact with hot accessible parts
- Degradation of insulation and of safety-critical components
- Ignition of flammable liquids
Examples of measures to reduce risks include:
- Taking steps to avoid high temperature of accessible parts
- Avoiding temperatures above the ignition point of liquids
- Provision of marking to warn USERS where access to hot parts is unavoidable
High temperature warning marking — you may use the following high temperature warning
marking:
4. Mechanical hazards
Injury may result from:
- Sharp edges and corners
- Moving parts which have the potential to cause injury
- Equipment instability
- Flying particles from imploding cathode ray tubes and exploding high pressure lamps
Examples of measures to reduce risks include:
- Rounding of sharp edges and corners
-Guarding
- Provision of SAFETY INTERLOCKS
- Providing sufficient stability to free-standing equipment
- Selecting cathode ray tubes and high pressure lamps that are resistant to implosion and
explosion respectively
- Provision of markings to warn USERS where access is unavoidable
To Next Page
Loading...
