20
caliper overhaul
13
Insert the Bleed Block into the caliper in place of the brake pads.
You will need to bleed your brakes before reinstalling
the brake pads.
Click here for detailed brake pad removal instructions
14
Spray isopropyl alcohol on the caliper and clean it with a rag.
Visually check your work. If there are any o-rings that are protruding beyond the outside edges of the banjo or bolt, remove and replace
the o-rings, then repeat the installation process.
Overhauling the caliper introduces a small amount of air into the system. It is necessary to bleed the brakes for optimal performance.
Click here for detailed brake bleed instructions
To Next Page
Loading...
Need help?
General
