28
brake bleed procedure
10
Hold both syringes upright.
Gently push on the caliper syringe plunger to move fluid from
the caliper syringe into the lever syringe until the lever syringe is
increased to 1/2 full and the caliper syringe is decreased to 1/4 full.
You should see bubbles form in the lever syringe.
11
Close the syringe clamp on the lever.
12
Pull the brake lever all the way to the bar with your finger and hold
it there until instructed to release the lever in a later step.
If you don’t want to hold the lever with your finger, have a friend hold it or you can
fasten it with a zip-tie or rubber band.
13
Pull out on the caliper syringe plunger to create a vacuum then
gently push in on the plunger to pressurize the system. Repeat this
procedure several times, until large bubbles stop coming out of
the caliper.
Do not pull the plunger past the end of the syringe.
To Next Page
Loading...
