8
English
Figure: Dome camera installation.
Connecting Cables
Refer to the diagrams in the Overview section for the location of the
different connectors.
To connect the cables required for proper operation, complete the
following:
1. If there are external input or output devices that need to be
connected to the camera (for example: door contacts,
relays, etc), connect the devices to the camera I/O
Terminals.
For more information, see Connecting to External Devices.
2. If an external microphone or external video monitor needs
to be connected to the camera, connect the devices to the
camera Audio/Video Connector.
For more information, see Connecting to Microphones and
Video Monitors.
3. Connect a network cable to the camera’s Ethernet Port (RJ-
45 connector).
• Wrap the cable once around the interior base of the
dome housing before you make the connection.
This will ensure the cable connector is not over-
stressed and cause poor video performance.
To Next Page
Loading...
