10
LED Indicators
Once the camera is connected to the network, the camera’s connection status LEDs will
display the camera’s progress in connecting to the Network Video Management
software. The following table describes what the LEDs indicate:
Table 2: LED Indicators
Connection
State
Connection
Status LED
Description
No Link Off Usually indicates that the camera is not
physically connected to any network device.
Obtaining IP
Address
One short flash
every second
The camera is attempting to obtain an IP
address.
Connecting to
NVR
Two short flashes
every second
The camera has obtained an IP address and
is ready to be connected.
Upgrading
Firmware
Two short flashes
and one long flash
every second
The camera is updating it’s firmware.
Connected On The camera is connected to the Network
Video Management software.
To Next Page
Loading...
