2. To configure a digital output:
a. In the Digital Outputs area, enter a name for the digital output in the Name field.
b. Select the appropriate state in the Circuit State drop down list.
c. In the Duration field, enter how long the digital output is active for when triggered. You can enter
any number between 100 and 3,600,000 milliseconds.
d. Click Trigger to manually trigger the digital output from the web interface.
e. Click Apply to save your changes.
Microphone
If a microphone is connected to the camera, you can adjust the gain on the Microphone page. The higher the
gain setting, the higher the microphone volume.
l Enter a number between the available range displayed on the right then click Apply.
Speaker
If a speaker is connected to the camera, you can adjust the volume on the Speakers page.
l Enter a number between 0 and 100 to set the speaker volume then click Apply.
Users
On the Users page, you can add new users, edit existing users, and change passwords.
Adding a User
1. On the Users page, click Add....
2. On the Add User page, enter a username and password for the new user.
3. In the Security Group drop down list, select the access permissions available to this new user.
l Administrator: full access to all the available features in the camera web interface, including PTZ
controls.
l Operator: has access to the Live View and PTZ controls but limited access to the Setup features.
The new user can only access the Image and Display page, Compression and Image Rate and
Image Rate page, Motion Detection page, Privacy Zones page, Digital Inputs and Outputs page,
Microphone page and the Speakers page. The new user can also configure onboard storage
settings but cannot delete video recordings or format the SD card.
l User: has access to the Live View and optional PTZ controls, but cannot access any of the Setup
pages. To enable the PTZ controls, select the Use PTZ Controls check box.
4. Click Apply to add the user.
Microphone 17
To Next Page
Loading...
