Editing PTZ Tours
1. Among the Setup options, click PTZ Tours.
2. Click Edit.
3. Make the changes you need.
4. To undo the changes that you’ve made, click Discard Changes.
5. Click Apply to save your changes.
6. To delete the tour, click Delete Tour. When the confirmation dialog box appears, click OK.
PTZ Limits
Depending on where the PTZ camera is installed, you may want to limit the movement and zoom of the camera
so that obstructions are never in view. For example, if the PTZ camera is installed close to the side of a building,
you can set the limits so that the PTZ camera cannot move to show the wall it is installed against.
1. From the left menu pane, click PTZ Limits.
2. To limit the maximum movement range, you can do one of the following:
l
In the image panel, move the PTZ camera as far left as you want to display then click the From
icon for the Pan Limit. Move the camera to the farthest point to the right and click the To icon.
Repeat this procedure for the Tilt Limit, only move the camera up and down. For information about
moving the PTZ camera, see Using the PTZ Camera Controls on page4.
l Below the image panel, you can set the Pan and Tilt Limit by adjusting the position of the two
black dots on each circle. The gray area shows the set degree of movement. The Pan Limit sets
the horizontal movement range and the Tilt Limit sets the vertical movement range.
3. To set the Lens Zoom Limit, enter a maximum zoom level.
4. To set the Maximum Move Speed, enter a maximum number of degrees per second.
5. To allow the camera to automatically correct the video image when the camera tilts more than 90°, select
the Enable E-Flip check box. When this option is disabled, the video image is upside down when the
camera tilts more than 90°.
6. Click Apply to save your settings.
Editing PTZ Tours 23
To Next Page
Loading...
