Live View
After you log in, the first page you see is the Live View. The Live View contains an image panel that displays the
live video stream.
If you are accessing an HD Multisensor Dome Camera, there may be up to four image panels displayed. Click an
image panel to zoom and control the image that is displayed.
Use the menu links in the top-left corner to navigate through the web interface. Click Live View any time to
return to this page.
The following sections describe the buttons that may be displayed under the image panel if users have access
to Pan-Tilt-Zoom (PTZ) controls. PTZ controls allow users to control the zoom, focus and positioning of a camera.
To give a user PTZ controls, see Adding a User on page17.
NOTE: Some options are disabled if they are not supported by the camera.
Using the Camera Zoom and Focus Controls
l To zoom out, move the slider towards the right.
l To zoom in, move the slider towards the left.
l To focus towards zero:
l Click << to take a large step.
l Click < to take a small step.
l Click 0 to focus at zero.
l To focus towards infinity:
l Click >> to take a large step.
l Click > to take a small step.
l Click Inf to focus at infinity.
l If the camera supports auto focusing, click Auto Focus.
Using Camera Presets
Users can save frequently used zoom and focus configurations as presets on the Live View page.
1. On the Live View page, use the Zoom and Focus controls to focus the camera on a specific point in the
video image.
2. To add this camera position as a preset, enter a name in the Add Preset field then click Add.
3. To use a preset, select a configured preset from the Presets drop down list and click Go.
4. To delete a preset, select a preset from the drop down list then click Remove.
The presets can also be configured in the Avigilon Control Center Client software through the PTZ controls.
Live View 3
To Next Page
Loading...
