The All Heads tab is only displayed on the Image and Display page. The Image and Display page allows you to
change settings that apply to the whole camera and settings that can apply to specific camera heads.
1. Select the All Heads tab to adjust the settings that apply to the whole camera. These settings include
Flicker Control, WDR, Saturation, Brightness, Sharpness and Contrast.
2. In the All Heads tab, you can set the Imaging mode to Global or Per-head:
l Global — apply the same settings to all camera heads. Use the settings listed in the All Heads tab
to adjust the camera image settings. The same settings for each numbered tab is disabled.
l Per-head — apply different settings to each camera head. Select the different tabs to change the
settings for each camera head.
3. Select each numbered tab to adjust the zoom and focus controls for each camera head. These settings
must be manually adjusted for each camera head.
For more information about the different Image and Display settings, see Image and Display on page8.
Changing Settings Per Camera Head 21
To Next Page
Loading...
