1. If you are planning to use onboard storage, insert a microSD card into the SD card slot on the H4
Multisensor camera. For more information, see (Optional) Configuring microSD Card Storage on page53.
2. Use a screwdriver to push each of the clamps into their top positions and ensure their springs are fully
compressed. In one smooth motion, push each clamp up (a), clockwise (b), up again (c), and then counter-
clockwise (d).
(Optional) Cutting the Mounting Hole for the In-Ceiling Mount Adapter
This procedure is not required if you are planning to install the camera with a metal ceiling panel (H4AMH-DC-
CPNL1).
(Optional) Cutting the Mounting Hole for the In-Ceiling Mount Adapter 47
To Next Page
Loading...
