Configuring Data Aging
1.
In the New Task menu , click Site Setup.
2.
Select a server, then click Recording and Bandwidth.
The Data Aging column shows an estimate of the recording time that is available at each image rate,
given the amount of space on the recording device.
3. In the Data Aging column, move the sliders to adjust the amount of video that is stored at each image
rate.
l To change the data aging settings for all linked cameras, move the slider for one linked
camera and all linked cameras will be updated.
l To change the data aging setting for one camera, break the camera's link to other cameras by
clicking the icon to the left of its name, then make your changes.
4. In the Max. Record Time column, manually enter a maximum record time or select one of the options
from the drop-down list for each camera.
Note: If the time estimated in Total Record Time is significantly shorter than the Max. Record
Time, the camera's actual recording time will be closer to the Total Record Time estimate.
The total recording time assumes continuous recording, and will increase with a Recording
Schedule.
5. Click OK.
Add Users and Groups
Add users and different permission groups for accessing the system.
Adding a User
Add users to monitor and manage your site.
1.
In the New Task menu , click Site Setup.
2.
Click the site name, then click Users and Groups.
3. Click Add User.
4. Complete the User Information area.
5. Select the Disable user checkbox to create an account, but prevent access.
6. In the Login Timeout area, select the Enable login timeout checkbox to set the maximum amount of
time the Avigilon Control Center Client software can be idle before the user is automatically logged
out of the application.
Configuring Data Aging 32
To Next Page
Loading...
Need help?
General
