3. In outdoor installations, the sun shroud should be set as far forward as possible without intruding on the
video image. Slide the sun shroud forward or back to protect the camera against glare from the sun.
4. Tighten the adjustment screws on the mount arm to secure the camera’s position.
5. In the camera web browser interface or the Avigilon Control Center software adjust the camera’s Image
and Display settings. You can set the zoom position, focus and change the image rotation.
(Optional) Configuring Onboard SD Card Storage
To use the camera’s onboard storage feature, you must insert an SD card into the SD card slot.
It is recommended that the SD card have a capacity of 8GB or more, and a write speed of class 6 or better. If the
SD card does not meet the recommended capacity or write speed, the performance of the onboard storage
may suffer and result in the loss of frames or footage.
1. Insert an SD card into the camera.
CAUTION — Do not force the SD card into the camera or you may damage the card and the
camera. The SD card can only be inserted in the orientation shown on the camera.
2. Access the camera’s web interface to enable the onboard storage feature. For more information, see the
Avigilon High Definition H.264 Camera Web Interface User Guide.
Zooming and Focusing the Camera
l In the camera web browser interface or the Avigilon Control Center Software, use the camera’s Image
and Display settings to zoom and focus the camera.
a. Use the zoom buttons to zoom the camera in or out.
b. Click Auto Focus to focus the lens.
c. If the preferred focus was not achieved, use the focus near and far buttons to adjust the focus.
Configuring the Camera
Once installed, use one of the following methods to configure the camera:
(Optional) Configuring Onboard SD Card Storage 12
To Next Page
Loading...
