4. Electronic avionics set up
• Requiring a minimum 6 channel receiver bound to your transmitter plug in all the corresponding
channels.
• These controls include the Throttle, Ailerons, Elevator, Rudder, Flaps and cargo door.
• Plug your 4S LiPo flight battery into the XT-60 battery connector that powers up your Bushmule.
• Check the rotation of the outrunner motors, they should both spin in opposite direction. Either both
towards the fuselage or towards the wing tips.
• Check all your control services and make sure they are all operating the correct way without any
binding issues. Adjust mechanically if they are not equally centered.
5. Control Set-up
• The Avios Bushmule handles extremely well, is very manoeuvrable through all ranges of the flight
envelope. In saying this your Avios Bushmule needs setting up before your initial maiden flight.
After the first flight the you can adjust the control surfaces to suite your own preference.
8
To Next Page
Loading...
