58 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide
To set the time zone using predefined time zone:
1. Click Applications Settings - Date And Time - Time Zone. The Time Zone screen is displayed.
2. Select Predefined to activate the time zone list pull-down menu.
3. Select the required time zone from the pull-down menu.
4. Click Save.
To define custom time zone settings:
1. Click Applications Settings - Date And Time - Time Zone. The Time Zone screen is displayed.
2. Select Define Time Zone to activate the fields used to create a user-defined time zone.
3. Enter the Time Zone Name and Standard Time Acronym of your choice.
4. Enter the GMT Offset (for example: -7:00).
5. Select Enable daylight savings time to activate the fields used to configure daylight savings
time settings.
6. Select or enter the required values for daylight savings time settings.
7. Click Save.
Boot Configuration
Boot configuration defines the location from which the console server loads the operating system.
The console server can boot from its internal firmware or from the network. By default, the ACS
6000 console server boots from Flash memory. Clicking Appliance Settings - Boot Configuration
will display the Boot Configuration screen.
If you need to boot from the network, make sure the following prerequisites are met:
• A TFTP or BootP server must be available on the network
• An upgraded console server boot image file must be downloaded from Avocent and made
available on the TFTP or BootP server
• The ACS 6000 console server must be configured with a fixed IP address
• The boot filename and the IP address of the TFTP or BootP server is known
To configure boot configuration:
1. Click Applications Settings - Boot Configuration. The Time Zone screen is displayed.
2. Under Boot Mode, select From Flash, and select Image 1 or Image 2.
-or-
Select From Network, and enter the following information:
• Appliance IP Address: Enter the fixed IP address or a DHCP assigned IP address to the
console server.
• TFTP Server IP: Enter the IP address of the TFTP boot server.
To Next Page
Loading...
