Avocent LONGVIEW - Setting the OSD Timeout

24 LongView® IP KVM Extenders Installer/User Guide
To change networking information for the user station and transmitter:
1. Press Print Screen and select the Net tab to configure network parameters for your LongView
IP KVM user station or transmitter.
Figure 3.2: Network Config Menu (Receiver)
2. To change the user station network configuration, select Rcvr from the Network Config menu
and fill out the desired information.
- or -
To change the transmitter network configuration, select Trans from the Network Config menu
and fill out the desired information.
3. Click Apply to save the changes.
Setting the OSD timeout
The amount of time the OSD is displayed on the monitor is configurable.