Avocent LONGVIEW - Configuring the OSD Hotkey Sequence

44 LongView® IP KVM Extenders Installer/User Guide
To access the Session Retry Menu:
1. Press Enter to display the serial menu.
2. Press 1 to access the Receiver Main menu and press Enter. If the password option is enabled,
you will be prompted for a password.
3. Press 8 to access the Console Settings Menu and press Enter.
4. Press 1 to access the Session Retry Menu and press Enter.
Figure 3.24: Session Retry Menu
To change the retry settings:
1. On the Session Retry Menu, press 1 to choose the Session Retry Timeout Seconds option and
press
Enter to change the time interval between retry attempts. You will be prompted to enter a
new time-out value in SS (seconds) format.
2. Type a value between 1 and 60 (inclusive) and press Enter.
3. To confirm your selection and exit the screen, type 0 (zero) and press Enter.
Configuring the OSD Hotkey Sequence
To change the hotkey sequence that activates your OSD:
1. From the serial menu, press 1 to access the Receiver Main Menu and press Enter. If the
password option is enabled, you will be prompted for a password.