Chapter 3: Operations 31
To configure the network settings for the user station:
1. Press 1 to select the Receiver Network Config option in the Network Configuration Menu and
press
Enter.
Figure 3.11: Receiver Network Configuration Menu
NOTE: The reset option in the Receiver Network Configuration Menu applies only to network settings.
2. Press 1 to select the Receiver IP Address option and press Enter.
3. Type a valid IP address and press Enter.
4. Press 2 to select the Receiver Netmask option and press Enter.
5. Type a valid Receiver Netmask and press Enter.
6. Press 3 to select the Receiver Default Gateway option and press Enter.
7. Type a valid Receiver Default Gateway and press Enter.
8. Press 5 to select the Static/DHCP Network Configuration option to toggle between Static and
DHCP mode. Press
Enter.
To Next Page
Loading...
