If you selected TFTP, enter the server IP address and firmware file you wish to load.
-or-
If you selected FTP or HTTP, enter the server IP address and firmware file you wish to load, as
well as the username and password.
5. Click the Up g rad e button.
4.4.3 Saving and restoring configurations and user databases
You cansave the switch configuration to a file. The configuration file contains information about the
managed switch. You can also save the local user database on the switch. After saving either file, you can
also restore a previously saved configuration file or local user database file to the switch.
To save a managed switch configuration or user database of a managed switch:
1. From the side navigation bar, click Un it View - Ap p lian ce - O v erview.
2. Click either the S av e Ap p lian ce C on fig u ration or Sav e A p p lian ce User Datab ase, then click the
Sav e tab.
3. Select the file save method: Filesy stem , T FT P, FT P or HT T P PUT .
4. If you selected TFTP, enter the server IP address and firmware filename you wish to load.
-or-
If you selected FTP or HTTP, enter the Server IP address, username, password and firmware
filename you wish to load.
5. Click the Down load button.
6. In the Save As dialog box, navigate to the desired location and enter a name for the file. Click
the S ave button.
To restore a managed switch configuration or user database of a managed switch:
1. From the side navigation bar, click the Un it View - Ap p lian ce - O v erview.
2. Click either the R estore Ap p lian ce Con fig u ration or R estore Ap p lian ce User Datab ase, then
click the R estore tab.
3. Select the file save method: Filesy stem , T FT P, FT P or HT T P.
4. If you selected Filesystem, click the Browse button to specify the location of the firmware
upgrade file.
-or-
If you selected TFTP, enter the server IP address and firmware filename you wish to load.
-or-
If you selected FTP or HTTP, enter the server IP address, username, password and firmware
filename you wish to load.
5. Click the Browse button. Navigate to the desired location and select the file name. Click the
Up load button.
6. After the success window appears, reboot the managed switch to enable the restored
configuration.
Vertiv | Avocent® AutoView™ 2108/2216/3108/3216 Switch Installer/User Guide | 31
To Next Page
Loading...
Need help?
General