Avol itrio - PLC product

Installation
13
English
External Device
TV2
Adapter
Adapter
Transmitter Receiver
1)
2)
3)
4)
5)
6)
Transmitter power/ LED o -> Please check the power connection
All LEDs of transmitter blink -> It would take around 1min 30sec for booting. Please unplug the power
adapter and connect again when it keeps blinking.
Input source LED of transmitter blink -> When there is no input source signal or input unsupported signal.
It needs to connect input source cable or change video resolution.
Power LED of receiver blinks -> When there is disconnection from the transmitter, because the distance
between transmitter and receiver is too far or malfunction of the PLC modem. Please locate transmitter and
receiver in near place and check the PLC operation.
All LED of receiver blink -> It would take around 1min 30sec for booting. Please unplug the power adapter
and connect again when it keeps blinking.
Output source LED of receiver blink -> Because of the dierentiation between output resolution and
resolution of output monitor, output is only supported with low resolution. It needs to be connected with
high resolution monitor.
■
Trouble shoot
2
1
35
4
6