Page 34 - Fehler! Formatvorlage nicht definiert.. Fehler! Formatvorlage nicht definiert.
AZUREM2.DOC 18.03.1999 12:40
groups are available on the tablet.
You can control the position of the fixture by drawing on the Stage area of
the tablet.
You can “train” the Azure so that it knows how all the lights are set up.
Then when you point at the stage area of the tablet, all the lights will point
at the same place on the stage. This is called “Tracking mode”. The
Reference manual tells you how to do this and how to use tracking mode.
If you press on the Nudge button, when you draw on the tablet the fixture
will move relative to its current position. This can be useful if you want to
slightly reposition a fixture. Press on the Absolute button to turn off this
mode.
You can control the intensity of the selected fixtures by drawing on the
Dimmer area.
If the fixture can do colour mixing, you can set the colour by drawing in
the colour mix area of the tablet.
You can recall the first 60 palette entries by pressing the pen on the
Focuses buttons.
You can change individual attributes of selected fixtures by pressing the
pen on to the attribute button, then (without lifting the pen) drawing up
and down on the tablet.
On the right hand side of the tablet, some of the programmer functions are
available, such as Clear and Locate Fixtures.
To Next Page