Page 138 - Fehler! Formatvorlage nicht definiert.. Fehler! Formatvorlage nicht definiert.
AZUREM2.DOC 18.03.1999 12:40
?? A - save the current speed of the chase (set using the left hand wheel)
?? B - save the direction of the chase (set using the direction / bounce
options, see below)
?? C - turn on random mode (steps are executed in random order) - press
to change the mode. Turn off random mode when editing a chase,
or you won’t know which step you are going to get next.
?? D - make the chase stop on the final step - If the final step is a
blackout, the chase will appear to turn itself off, so you can just
press Go whenever you want to make it happen again
?? F - Displays more options…
?? a - Chase start options (press the button to cycle through the options):
Fader reloads chase (every time you turn on the chase it starts at
step 1)
Fader stops/starts chase (every time you turn on the chase it
continues from where it left off)
Fader stops, go to start chase (the chase will not run until you
have pressed Go after you turn on the chase).
?? b - Skip wait and fade time options (press button to cycle through)…
Skip first wait time (The wait time is missed when the chase is
first turned on)
Skip first wait and fade time (Both wait and fade times are missed
when the chase is first turned on)
Wait and Fade for all steps.
?? c - Manual mode allowed/disallowed - Lets you manually fade a paused
step by turning the left hand wheel for the HTP channels and the
right hand wheel for the LTP channels.
?? d - Speed wheel allowed/disallowed - Lets you change the speed using
the left hand wheel. You might want to turn this off if you want
chase speeds to be always played back as they are recorded.
B: Insert Step - The contents of the programmer are inserted as a new
step between the current step and the next step (so you need to set
up the step that you want to save before selecting the option). The
Azure will make up a decimal number that fits between the existing
step numbers.
The Azure can also renumber all the steps to make them whole
numbers (Softbutton A) and allows you to enter channel values
numerically to plot a scene (Softbutton B)
Press Enter to insert the new step.
C: Press to switch off Chase Tracking - Turns off the updating to the
chase times screen on the VGA display (the On Screen button above
the chase controls shows this screen). If there are more steps than can
be shown on one screen, the Azure will change pages so that the live
step is always on the screen if this option is turned on. This can be
difficult if you are selecting a step to change using the cursor keys
while the chase is running, so you can turn off the tracking.
E: Bounce = OFF - Allows you to create a bounce chase which runs
forward to the last step, then backwards to the first step, and so on.
F: Direction = UP - Allows you to change the direction of the chase. You
need to use the Parameters option B to save these settings
permanently.
To Next Page