Avonic CM93-IP User Manual

(RTP) Multicast Streaming
RTP Multicast
Get rtp multicast parameters
Code {"GetEnv":{"StreamRTPMulticast":{"nChannel":-1}}}
Set rtp multicast parameters
Code {"SetEnv":{"StreamRTPMulticast":[{"stSlave":{"nProtolType":0,"bEnable":0,"wMultiCastPort":4002,
"szMultiCastUrl":"224.1.2.3"},"stMaster":{"nProtolType":1,"bEnable":0,"wMultiCastPort":4000,
"szMultiCastUrl":"224.1.2.3"},"nChannel":0}]}}
NOTE: When modifying one param you should take along bEnable and awMultiCastPort. Otherwise, it will be set to 0. Suggesting that when
setting env, you can distinguish the stMaster and stSlave.
RTP Multicast Settings
RTP Multicast Settings
Function Code Command Setting
Enable {"SetEnv":{"StreamRTPMulticast":[{"stMaster":
{"bEnable":1,"wMultiCastPort":4004},"nChannel":0}]}}
bEnable 0: off
1: on
Protol Type {"SetEnv":{"StreamRTPMulticast":[{"stMaster":
{"bEnable":1,"nProtolType":1,"wMultiCastPort":4004}, "nChannel":0}]}}
nProtolType 0: RTP
1: TS
Multicast Address {"SetEnv":{"StreamRTPMulticast":[{"stMaster":
{"bEnable":0,"szMultiCastUrl":"224.1.2.23","wMultiCastPort":
4004}, "nChannel":0}]}}
SzMultiCastUrl 224.0.0.0~
255.255.255.0
Multicast Port {"SetEnv":{"StreamRTPMulticast":[{"stMaster":
{"bEnable":1,"wMultiCastPort":4004},"nChannel":0}]}}
wMultiCastPort Even [0, 65535]
Camera Settings
Video Parameters
Get video parameters
Code {"GetEnv":{"VideoParam":{"nChannel":-1}}}
Set video parameters
Focus
Function Code Command Setting
Focus Mode {"SetEnv":
{"VideoParam":[{"stAF":
{"emAFMode":2},"nChannel":0}]}}
emAFMode 2:
3:
4:
Auto
Manual
OnePush
AF-Zone {"SetEnv":
{"VideoParam":[{"stAF":
{"emAFZone":1},"nChannel":0}]}}
emAFZone 0:
1:
2:
3:
4:
5:
Front Focus
Back Focus
Meeting
Education Tracking
Moving Objects
Center Focus
AF-Sensitivity {"SetEnv":
{"VideoParam":[{"stAF":
{"nSensitivity":1},"nChannel":0}]}}
nSensitivity 1:
2:
3:
High
Middle
Low
78

Avonic CM93-IP Specifications

General

Brand	Avonic
Model	CM93-IP
Category	Security Camera
Language	English