14
Troubleshooting
·Verify Power - Check that the power supply is properly connected and on an active circuit.
·Verify Connections - Check that all cables are properly connected.
·TX/RX Indicator Troubleshooting Lights - Pg. 5-6
·IR Issues - Verify correct connections - P. 8-9
Note: Visibly ashing Emitters may not function properly, if you are experiencing issue try the
IR Cables that come in the box.
·Lights indicate everything is good but still not getting a picture, this may be a bandwidth
limitation. See Bandwidth Chart below to verify the signal is not exceeding the bandwidth of
the Extender kit (limited to 10.2Gbps).
Bandwidth Chart
To Next Page
Loading...