AVS Electronics CAPTURE 8 - Communication Modules and Configuration

- 20 -
PSTN Telephone - Technical features
The PSTN telephone is directly integrated on the control panel electronic board, its functioning is subject to the enabling, during programming, of
the PSTN telephone section.
Connection of the telephone line
AB : connection to the incoming telephone line, upstream of all eventual system telephone
appliances.
A’B’: connection to the eventual system telephone appliances.
Note: x the telephone cable using the appropriate turret.
Outdoor connections: • internal changed and derived telephone line
Proles of phone numbers: • n° 16 numbers, can be associated to any alarm event or technical
Protocols: •
•
•
•
•
FAST FORMAT with assignable channels
VOCAL (with optional board mod. DGVOC)
SIA 1st Level and SIA 2st Level
SIA_HAYES for hayes XM40Plus modem or AVS certicate
CONTACT-ID
Time transmission of alarms •
•
D2 Vocal mode 12 sec., M2 vocal mode 12 sec.
D2 Contact ID 16 sec., M2 Contact ID 19 sec.
Type of interface • Proprietary interface compliant to ETSI ES 203-21 and RTTE
DIGIVOC (optional) - Technical features
DIGIVOX is a device that, when inserted properly, provides the ability to centrally send voice messages
Insertion in the board
a. Completely switch off the power to the control panel.
b. Insert the vocal synthesis board on the control panel board,
introducing the connector place in front of the board lower
face with the female J6 (Memory Card) placed on the
control panel board.
c. Press smoothly until its complete insertion.
d. Switch on the power to the control panel
PSTN + GSM
If you want to have both the phone line that the GSM channel, you must connect the telephone line to the control panel and insert the card XGSM
on Central or connect the card XGSM485 / XGSM485Pro in serial.
The calls management is subject to the type of interface chosen during programming..
S7
BATTERY
AC
J3
CONN ETH
S5
J4
1
SERVICE
J5
MEMORY
CARD
J2
USB
SNATCH
TAMPER
S1
PB1
OC1
OC2
OC3
J1
CONN GSM
L2
DA DB
L1 L3 L4
L5
L6
L7
L8
T
NO NC
C
A B A' B'
Protocols: • VOCAL
Messages: •
•
The control panel enables the recording of forty (n. 40) customised vocal messages for a total time of
120 seconds.
A library of pre-recorded messages allows automatic and personalized
composition of alarm messages and different technical events
RTC Remote Telephone Control: • Programmable activation for any single user prole
Tension: • Nominal tension: : 12 V =
Working Temperature: • temperature -10°C / + 55°C - humidy 95%
Consumption: •
•
in quiet: 10 mA
in transmission: 30 mA
S7
BATTERY
AC
J3
CONN ETH
S5
J4
1
SERVICE
J5
MEMORY
CARD
J2
USB
SNATCH
TAMPER
S1
PB1
OC1
OC2
OC3
J1
CONN GSM
L2
DA DB
L1 L3 L4
L5 L6
L7
L8
T
NO NC
C
A B A' B'
Plug-in
connector