This mode allows the
installer/owner to verify that
each trigger of the alarm
system is working, without
having to arm and disarm the
system each time and set off
the siren.
After pressing the remote 9
times to enter this mode, turn
the ignition to OFF. The siren
will chirp and the indicators
will flash to indicate a trigger
eg. push the bonnet switch,
open a door, hit the vehicle.
The siren will chirp four times
to indicate a pre-warning
impact sensor detection, or
once to indicate full alarm
trigger level.
Turn the ignition to ON to exit
this mode.
To Next Page
Loading...
