AVS 9000 - SMS Operation; Sending an SMS to the Alarm; Receiving an SMS from the Alarm; Normal Operation (Arming)

8
SMS operation
Sending an SMS to the alarm
From a mobile phone type the secure operation PIN code followed
by the command.
Example: 000000COMMAND
Tips
• You must put the secure operation PIN code at the start of
each command
• The message is not case sensitive
• Do not use spaces
• The reply SMS will be sent back to the same phone the
command SMS was sent from
Receiving an SMS from the alarm
• The AVS 9000 will reply to any command SMS sent to it
• It will reply to the same phone the command came from
• The AVS 9000 will identify itself at the start of each SMS. To
change this see AVS 9000 system identification (ID).
Normal operation
Arming
By SMS
1. Type your PIN code and ARM (or A)
Example: 000000ARM or 000000A
2. The indicators will flash once and the siren will chirp once.
3. The doors will lock (if optional central locking installed).
4. The LED light on the dash will light solid for 20 seconds.
5. The LED light will then start flashing. The system is now
armed.
6. You will receive a SMS reply with the alarm state:
Example: ALARM ARMED