AVS A-SERIES INSTALLATION MANUAL - GEN 2 VER 5
Contents
Note: items in red have been added or amended for this version of the installation manual.
General system functions
• Polyfuse protected inputs/outputs
• Auto-immobilisation
• Arm by remote
• Door ajar warning
• Disarm by remote
• Low remote battery warning
• Panic/car finder
• Boot release output (150mA max)
• Auto zone bypass
• Door/bonnet/boot inputs
• Turbo timer functions
• Operate system from car’s factory remote
• Anti hijack modes
• Courier feature
• Automatic re-arm and re-lock
Additional features
• Data battery back-up siren V2
• Intelligent glass break sensor (AVS A5)
Remote controls
• Learning new remotes
• Learning new remotes when no working remotes are available
• Deleting remotes
Emergency disarm / PIN code override
Wiring instructions
• Supply voltage
• Current consumption
• Location of main control unit
• Plug connector
• Upgrade interface loom
• Plug-in sensor loom
Data battery back-up siren V2 wiring
Changing programmable features
Programming features Register 1
• Arm and disarm chirp
• No door ajar warning
• Instant boot release / On board turbo timer shut down
• Negative on alarm / pager out
• Inhibit / enable mode selection for factory remote interface inputs
• Installer mode
To Next Page
