ADVANCED OPERATION
19
4) PORT
The valid number ranges from 1 to 9999. The default value is 80. Typically, the TCP port used by HTTP is 80.
However in some cases, it is better to change this port number for added flexibility or security.
See the example below:
STATIC
NETWORK TYPE STATIC
IP 192 . 168 . 001 . 012
GATEWAY 192 . 168 . 001 . 254
NETMASK 255 . 255 . 252 . 000
PRIMARY DNS 168 . 095 . 001 . 001
SECONDARY DNS 139 . 175 . 055 . 244
PORT 0080
PLEASE CONSULT YOUR INSTALLER FOR ADVANCE SETTING
uv SELECT s BACK t NEXT ENTER
5.7.2. PPPOE
5) NETWORK TYPE
Select the network type as PPPOE.
6) USER NAME / PASSWORD
Set the “username” and “password” subscribed from your ISP supplier
7) DNS (PRIMARY DNS / SECONDARY DNS)
Key in the IP address of the domain name server obtained from your ISP (Internet Service Provider).
8) PORT
The valid number ranges from 1 to 9999. The default value is 80. Typically, the TCP port used by HTTP is 80.
However in some cases, it is better to change this port number for added flexibility or security.
See the example below:
PPPOE
NETWORK TYPE PPPOE
USER NAME EMPTY
PASSWORD EMPTY
IP 000 . 000 . 000 . 000
GATEWAY 000 . 000 . 000 . 000
NETMASK 000 . 000 . 000 . 000
PRIMARY DNS 168 . 095 . 001 . 001
SECONDARY DNS 139 . 175 . 055 . 244
PORT 0080
PLEASE CONSULT YOUR INSTALLER FOR ADVANCE SETTING
uv SELECT s BACK t NEXT ENTER
Note: The PPPOE function needs to have one “username” and one “password” subscribed from one ISP
supplier, and a “DDNS account” to correspond the dynamic IP address to a specific “Hostname”.
To Next Page
Loading...
Need help?
General
