Awox SMLm-c9-E27 - Resetting Devices

Ref: 1.8 User Guide LED Bulbs Bluetooth Mesh
AwoX Confidential Document – Do not copy Page: 59 of 60
2. Uncheck the bulb that you want to
disassociate from the remote control.
7.5 RESET
7.5.1 RESET A BULB
1. If possible, put your bulb in white (hot or cold no matter ...). The reset procedure works better when
the bulb is white rather than color.
2. In the steps below, the power is turned off. It is not ON / OFF done using the remote control or the
application, but electrical ON / OFF.
3. Your light bulb is off. This is the beginning of the procedure.
4. Turn it on briefly (one second) and turn it off
5. Allow 6 seconds
6. Turn it on a second time briefly (one second) and turn off
7. Allow 6 seconds
8. Turn it on a third time briefly (one second) and turn off
9. Allow 6 seconds
10. Turn it on for a fourth time (12 seconds) and turn off
11. Allow 6 seconds