Ref: 1.8 User Guide LED Bulbs Bluetooth Mesh
AwoX Confidential Document – Do not copy Page: 60 of 60
12. Turn on the fifth time (12 seconds) and turn off
13. Allow 6 seconds
14. Turn it on. The bulb will then reset and flash green. Then it will return to its initial red state.
7.5.2 RESET OF A REMOTE
Press the ON and COLOR CYCLE buttons on the remote control simultaneously for 4 seconds. The LED
on the front panel should flash.
7.6 IF YOUR BULB DOES NOT LIGHT IN RED WHEN UNPACKING
If your bulb does not light red when unpacking, refer to Chapter Erreur ! Source du renvoi introuvable. to
reset.
To Previous Page
Loading...
