AWS Storage Gateway - Page 239

AWS Storage Gateway User Guide
Performing Tasks on the VM Local Console (File Gateway)
To Do This
Configure an HTTP proxy Enter 1.
You need to supply a host name and port to
complete configuration.
View the current HTTP proxy configuration Enter 2.
If an HTTP proxy is not configured, the message
HTTP Proxy not configured is displayed. If
an HTTP proxy is configured, the host name and
port of the proxy are displayed.
Remove an HTTP proxy configuration Enter 3.
The message HTTP Proxy Configuration
Removed is displayed.
4. Restart your VM to apply your HTTP configuration settings.
Configuring Your Gateway Network Settings
The default network configuration for the gateway is Dynamic Host Configuration Protocol (DHCP). With
DHCP, your gateway is automatically assigned an IP address. In some cases, you might need to manually
assign your gateway's IP as a static IP address, as described following.
To configure your gateway to use static IP addresses
1. Log in to your gateway's local console:
• For more information on logging in to the VMware ESXi local console, see Accessing the Gateway
Local Console with VMware ESXi (p. 273).
• For more information on logging in to the Microsoft Hyper-V local console, see Access the
Gateway Local Console with Microsoft Hyper-V (p. 274).
2. On the AWS Appliance Activation - Configuration main menu, enter 2 to begin configuring your
network.
API Version 2013-06-30
232