Axel WOLF - Page 36

WOLF NETWORK CONFIGURATION IMPORT / EXPORT FILE
Axel Technology |
36
23
RDS_UECP_PROPAGATION=On
Dissemination of UECP data from Wolf device
and retransmission thereof, filtered or not, to
other UECP compatible devices
See Target Propagation Settings
24
AUTO_TIME_SYNC=Off
25
EXTENDED_TCPIP_PORT_SEL=Serial_2
26
NTP_LOCAL_TIME_OFFSET=+0:00
NTP service offset
[END_GENERAL_SETTINGS]
[TARGET_PROPAGATION_SETTINGS]
27
DEST_ENCODER_ADDRESS=0
Destination Encoder Address for UECP packets
received by Wolf
28
DEST_SITE_ADDRESS=0
Destination Site Address for UECP packets
received by Wolf
[END_TARGET_PROPAGATION_SETTINGS]
[MEASURES_SETTINGS]
29
AUDIO_REFERENCE=+3.5dBu
Analog Audio Input Setpoint for both Analog-1
and Analog-2
30
DIGITAL_REFERENCE=-21.7dBFs
Digital Audio Input Setpoint
31
MPX_0_REFERENCE=+0.0dBu
Local CoderMPX-0 input setpoint
32
MPX_1_REFERENCE=+0.0dBu
MPX-1 input setpoint
33
MPX_2_REFERENCE=+0.0dBu
MPX-2 input setpoint
34
DECODER_DEEMPHASIS=50us
De-emphasis value setting for decoder MPX
Possible values: 0, 50,75 µS
35
DECODER_PILOT_RDS_COMPENSATION=1.15dB
This parameter represents a correction factor
that is entered to offset the loss of audio level
generated on the stereo audio signal, due to
the deviation lost because of the Stereo Pilot
injection and the Carrier with RDS data
modulation.
Depending on the Pilot level and the RDS level
used, this parameter allows you to bring the
audio level meter to zero.
With the same deviation, the audio
level changes according to the
deviation lost because of the RDS
and the Pilot, and this parameter is
used to realign the measurement to
offset this loss. The default value is
the compensation required for a -
21dB pilot and a -28dB RDS.
[END_MEASURES_SETTINGS]
[MASTER_IDENTIFICATION]
36
NATIONAL_MASTER=0
37
OFFLINE_MASTER_ID=0
[END_MASTER_IDENTIFICATION]
[AUTOMATIC_MODE_PRESET]
This section is for changeover operation, with
the relative exchange ranking.
38
AUTO_AUDIO_MAIN_SEL=Decoder_Mpx1
Selection of the Main Source for control and
broadcasting in Automatic
39
AUTO_AUDIO_BACKUP_SRC1_SEL=Decoder_Mpx2
FIRST Back-up broadcasting source
40
AUTO_AUDIO_BACKUP_SRC2_SEL=Digital_2
SECOND Back-up broadcasting source
41
AUTO_AUDIO_BACKUP_SRC3_SEL=Digital_1
THIRD Back-up broadcasting source
42
AUTO_AUDIO_BACKUP_SRC4_SEL=Off
FOURTH Back-up broadcasting source
43
ALARM_AUDIO_SILENCE_THR=-40.0dB
This parameter sets the audio threshold value
below which the sound is considered silence
44
ALARM_AUDIO_SILENCE_TIME=5sec
This parameter specifies how long (in seconds)
before the audio level below the
"ALARM_AUDIO_SILENCE_THR =" value
should be considered silence, in which case an
This parameter (43) is strictly linked
to parameter 44