11
AXIS 213 - Installing the AXIS 213
Manual Installation using ARP and Ping in Windows
Follow these instructions to assign a unique IP address to your product from a
computer on your network:
1. Acquire an unused IP address for the AXIS 213 from your network
administrator.
2. Connect a standard network cable to your AXIS 213 and connect it to the
network.
3. Locate the serial number/MAC Address (S/N) found on the label on the AXIS
213.
4. From a computer on your network, open a Command Prompt, i.e. from the
Windows Start menu, select Run... and type cmd in the field. Click OK.
5. Enter the commands:
Syntax:
Example
6. Connect the power to the AXIS 213.
7. When ‘Reply from 192.168.0.125: ...’ is displayed (approximately 10-15
seconds), type Ctrl+C to close the ARP Ping session.
8. Start a Web browser and enter the IP address in the Address/Location field.
9. Press Enter.
10.Enter a password for the root user (administrator).
11.If required, accept the installation of AMC onto your workstation. See AXIS
Media Control (AMC), on page 9 for more information.
12.The installation is now complete, proceed to Using the PTZ Network Camera, on
page 14.
arp -s <IP address> <MAC address>
ping -l 408 -t <IP address>
Note: The ping command is
followed by -l (lower case L)
To Next Page
Loading...
